Honeywell SiXSMOKE Smoke Detector Review

The Honeywell Lyric SiXSMOKE has finally been released and is available for shipping within the USA and Canada. The SiXSMOKE was announced at the same time as all of the other SiX Series sensors and where available for ordering but, these sensors were delayed for a few months. The Lyric smoke detector is compatible with the Honeywell Lyric Controller and other systems that can utilize SiX sensor. Once the SiXSMOKE is enrolled into the panel, it cannot be used with another control panel until it has been deleted first because of the Lyric Lock feature. Each Lyric smoke detector has a unique MAC number located on the sticker on the unit.

The wireless SiXSMOKE has a maximum coverage area of 50′ X 50′ and detects smoke/heat in two ways Fixed =135° F Heat Sensing and Rate-of-Rise Sensing of =15° F within 1 minute. One of the coolest features of the Lyric SiXSMOKE, when paired with a Lyric Controller is the fact that if you have more than one detector you can set up the One Go All Go feature which will activate all SiXSMOKE’s if one is triggered. You can place the Lyric SiXSMOKE within 300 feet of the alarm control panel which allows you to install in those back areas. The SiXSMOKE works on a a Direct Sequence, Spread Spectrum (DSSS), two-way radio utilizing the 2.4GHz RF band. In the 2.4GHz band, there are 16 channels available for SiX™. When the device registers with the control panel, it will automatically determine which frequency channel the panel is operating on.

When the SiXSMOKE photoelectric beam detects the presence of smoke, it will go into alarm and send the alarm signal to the Lyric Controller. The Lyric SiXSMOKE works best when you have professional alarm monitoring for your Lyric Security System. Once our central alarm monitoring station receives these signals we can dispatch the exact fire department for your area. During an alarm condition, pressing the detectors test switch will silence the piezoelectric horn for 5 minutes. When programmed in one-go-all-go mode, the detector can only be silenced from the controller. When the battery of the Lyric SiXSMOKE is no longer working you will need to replace it with One 3V lithium battery. Duracell DL123 and DL123A, Panasonic CR123A, Honeywell 466. Remove batteries for at least 10 seconds, before installing new ones.

Note: Do not mix old and new batteries, battery types or manufacturers. 

Honeywell SiXSMOKE Frequently Asked Questions

Honeywell SiXSMOKE Product Manuals

Leave a Reply

Your email address will not be published. Required fields are marked *